Keysight N9322C - Page 211

203
Command Reference
Power Meter Option Subsystem
Set Power Meter Measurement Interval Time
[:SENSe]:MEASure:INTerval:TIME <value>
[:SENSe]:MEASure:INTerval:TIME?
This command defines the power meter measurement
interval time.
Range: 1 ms to 200 s
Example: :MEASure:INTerval:TIME 1ms
Key access: Meas > General Setup > More 1 of 2 > Meas Interval
Set Power Meter Video Bandwidth Type
[:SENSe]:BANDwidth|BWIDth HIGH|MEDium|LOW|OFF
[:SENSe]:BANDwidth|BWIDth?
Use this command to toggle the video bandwidth type
between high, middle, low and off. It’s only available for
U2020 X series peak power sensor.
Example: :SENSe:BANDwidth HIGH
Key access: Meas > General Setup > More 1 of 2 > Video B/W
Set Power Meter Video Average Count
[:SENSe]:AVERage:VIDeo:COUNt <value>
[:SENSe]:AVERage:VIDeo:COUNt?
This command defines the average count number of power
meter. It’s only available for U2020X series peak power
sensor, and the trigger type must be set to continuos trigger
or single trigger. The count number parameter can only be
set to N- th power of 2.
[:SENSe]:AVERage:VIDeo:COUNt:AUTO OFF|ON|0|1
[:SENSe]:AVERage:VIDeo:COUNt:AUTO?
Use this command to turn on/off the average count of power
meter.
Example: :SENSe:AVERage:VIDeo:COUNt 16
Key access: Meas > General Setup > More 1 of 2 > Video Avg