Keysight N9322C - Page 217

209
Command Reference
Power Meter Option Subsystem
Query Limit Fail Result
:CALCulate:LIMit:FAIL?
Use this command to query the limit result. If get the result
0, it means power meter test result pass the limit. If get the
result 1, it means the power meter test result fail the limit.
Example: :CALCulate:LIMit:FAIL?
Query Limit Failure Count
:CALCulate:LIMit:FCOunt?
Use this command to query the quantity of limit fail test
points.
Example: :CALCulate:LIMit:FCOunt?
Set Gate Measurement Type
:CALCulate1:FEED1 PEAK|PTAV|AVER|MIN
:CALCulate1:FEED1?
This command to toggle gate measurement type between
Average, Peak, Peak to Average, and Minimum. It’s only
available when the display mode is set to Meter.
Example: :CALCulate1:FEED1 PEAK
Key access: Meas > Peak Setup > Gate Setup > Meas
Set Trigger Type
:TRIGger1:SOURce:ACQN FREErun|CONTinuous|SINGle
:TRIGger1:SOURce:ACQN?
This command toggles the peak power sensor trigger type
between Continuous Trigger, Single Trigger and Free Run.
Example: :TRIGger1:SOURce:ACQN FREErun
Key access: Meas > Peak Setup > Trig/Acq >Acqn