Keysight U8903B - U8903 B Bluetooth Card Verification; Equipment Used; Test Program; Test Procedure

Performance Verification for Bluetooth Card 5
Keysight U8903B Service Guide 85
U8903B Bluetooth Card Verification
The following test details the setup and steps needed to perform the functional verification
on the U8903B Bluetooth card.
Equipment used:
– Keysight U8903B audio analyzer with Bluetooth option
– RF cable with N-type male connector on both ends (length: 1.5 m or less)
Test program:
1 Ensure that the test PC is installed with VEE Pro 8.5 or later.
2 Obtain the U8903B-BT.zip file from the following location: http://www.keysight.com/
main/redirector.jspx?action=ref&cname=EDITORIAL&ckey=91494&cc=US&lc=eng
3 Extract the U8903B-BT.zip file to the C:\ directory of the test PC.
4 The extracted files will be located in the C:\U8903B-BT folder.
5 Run the VEE test program by double-clicking the U8903B-BT_noN4010_ v6.0.vee file in
the C:\U8903B-BT folder.
6 Set the Keysight U8903B GPIB address to 2.
7 Set the Device Under Test (DUT) GPIB address to 28.
Test procedure:
1 Connect the Keysight U8903B Tester RF1 port to the DUT RF1 port using the N-type
(male) to N-type (male) RF cable as shown in Figure 5-1.
Figure 5-1 Connecting the U8903B Tester RF1 port to DUT RF1 port for Keysight U8903B Bluetooth card
functional verification
RF cable
U8903B Tester
DUT
RF1 port
RF1 port