X-Series EMI Receiver Getting Started Guide 17
Quick Start
Instrument Information
Instrument Information
Power requirements
The only physical installation of your Keysight receiver is a connection to a
power source. Line voltage does not need to be selected.
This instrument does not contain user serviceable fuses.
AC power cord
The receiver is equipped with a three-wire power cord, in accordance with
international safety standards. This cable grounds the instrument cabinet when
connected to an appropriate power line outlet. The cable appropriate to the
original shipping location is included with the instrument.
The instruments can operate with mains supply voltage fluctuations up to ±10%
of the nominal voltage.
This is a Safety Class 1 Product (provided with a protective earthing ground
incorporated in the power cord). The mains plug shall only be inserted in a
socket outlet provided with a protective earth contact. Any interruption of the
protective conductor inside or outside of the product is likely to make the
product dangerous. Intentional interruption is prohibited.
Failure to ground the instrument properly can result in personal injury. Before
turning on the instrument, you must connect its protective earth terminals to
the protective conductor of the main power cable. Insert the main power cable
plug into a socket outlet that has a protective earth contact only. DO NOT
defeat the earth-grounding protection by using an extension cable, power
cable, or autotransformer without a protective ground conductor.
This product is designed for use in Installation Category II and Pollution Degree 2,
and Measurement Category None.
This instrument has autoranging line voltage input. Be sure the supply voltage is
within the specified range.
The Mains wiring and connectors shall be compatible with the connector used in
the premise electrical system. Failure, to ensure adequate earth grounding by not
using the correct components may cause product damage, and serious injury.
Always use the three-prong AC power cord supplied with this product. Failure to
ensure adequate earth grounding by not using this cord can cause product
damage.
To Next Page
Loading...
Need help?
General
