Keysight x-series Getting Started Guide

X-Series EMI Receiver Getting Started Guide 39
Instrument Operating System
User installation of software
User installation of software
3rd Party Software verified by Keysight
Keysight has verified that the following programs are compatible with the
instrument's applications:
—MathWorks MATLAB
Installation of other 3rd Party Software
The EMI Receiver’s platform is an Open Windows environment, so you can
install software on the instrument. However, installation of non-approved
software may affect instrument performance. Keysight does not warrant the
performance of the instruments with non-approved software installed.
If you install programs other than those that Keysight has tested, it could cause
problems with the instrument's applications. If this happens, you should try
uninstalling the program that has caused the problem, or try changing the
program's configuration. If this does not correct the problem, you may have to
use the Instrument Recovery system to reinstall the instrument's system
software.
Before installing any additional programs on the instrument, you should
exit the EMI Receiver application.
Also, you must not remove any applications or programs that were installed
on the instrument when it was shipped from the factory.

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)