56 X-Series EMI Receiver Getting Started Guide
Instrument Operating System
USB Connections
USB Connections
All of the USB ports are compatible with the USB 2.0/3.0 and 1.1 specification.
The three USB ports on the front panel (see graphic below) and three of the
USB ports on the rear panel are USB Series “A” ports. These are ports that you
can use to connect USB mass storage devices and printers. The instrument
USB Host support includes the standard Microsoft Windows USB drivers for
human interface, mass storage, printing, scanning, and imaging devices. A
complete up-to-date list of the Windows USB class driver support is available
on the Microsoft website.
The square USB port (see graphic below) on the rear panel is a USB 3.0 Series
“B” port and is used for controlling the instrument over USB. Information to
help you program your instrument is documented in the X-Series
Programmer’s Guide. The instrument USB device driver included in the
instrument software supports the test and measurement industry standard
USBTMC-USB488 device class.
Keysight Technologies does not support or warrant correct instrument
operation if additional USB drivers from third parties are installed in the
instrument. It is possible that additional drivers could break the normal USB
operation. If USB operation is broken, recovery would require reinstalling the
instrument application using the Instrument recovery process.
USB "A"
3.0
USB "A"
2.0
USB "B"
3.0
To Next Page
Loading...
Need help?
General
