Kia pride 1997 - Page 116

LIGHT BULBS
Se tee
Replacement of Halogen light bulb.
Disconnect the coupler "1".
Remove the sealing cover "2".
Unfasten the bulb retaining spring "3"
Remove the bulb.
Install the new bulb in the reverse
order of removal.
Cl PO NS
6-30
640
NOTE
Always check headlight aim and adjust
(if necessary) so as to conform with
applicable regulations.
Do not touch the bulb surface with the
bare fingers.
Install the sealing cover properly as
illustrated.
CAUTION
Halogen bulbs contain pressurized gas
which will produce flying pieces of
glass if broken. Therefore, always han-
dle carefully, and avoid scratching or
abrasion of the bulbs, and if the bulbs
are lit, avoid contact with liquids. the
bulb should only be operated when
installed in a headlamp.
If a bulb becomes damaged or cracked
replace it immediately and carefully
dispose of the damaged bulb.
Keep bulbs out of the reach of
children.