Kia pride 1997 - Manual Transaxle Operation

STARTING, MANUAL TRANSAXLE
ENGINE WARM
Depress '/2 down
and start engine
ENGINE FLOODED
Depress pedal to floor
and start engine
403
ENGINE WARM
1. Depress the accelerator pedal ABOUT
HALF WAY AND HOLD IT.
Do not pump.
2. Turn the ignition key to the "START"
position until the engine starts.
3. When the engine starts, release the
ignition key and accelerator pedal.
CAUTION
Extended high speed idling (5 minutes
or more) could produce an excessive
exhaust system temperature that can
damage your vehicle.
cs)
4-4
404
ENGINE FLOODED
If the engine is hot and won't start, it may
be flooded -- wait half a minute or more
before attempting to restart.
1. Depress the accelerator pedal to the
floor and hold it while cranking the
engine.
Do not pump.
2. Turn the ignition key to the "START "
position until the engine starts.
3. When the engine starts, release the
ignition key and accelerator pedal.
Manual Transaxle
Operation
Shift pattern
405
The shift pattern is conventional, as
shown above.
Press the clutch pedal down fully while
shifting, then release it slowly. A special
safety feature prevents inadvertent shift-
ing from 5 (Fifth) to R (Reverse). The
gearshift lever must be returned to the
Neutral position (as shown) before shifting
into R (Reverse).
NOTE
Make sure the vehicle is completely
stopped before shifting into R (Reverse).