Kia pride 1997 - Underbody Maintenance; Aluminum Wheel Maintenance

APPEARANCE CARE
Underbody Maintenance
Corrosive materials used for ice and snow
removal and dust control may collect on
the underbody. If these materials are not
removed, accelerated rusting can occur
on underbody parts, such as fuel lines,
frame floor pan, and exhaust system,
even though they have been provided
with rust protection. Thoroughly flush the
underbody and wheel housing of your
vehicle with lukewarm or cold water once
a month and at the end of each winter.
Pay special attention to these areas
because it is difficult to see all the mud
and dirt. It will do more harm than good to
wet down the road grime without remov-
ing it. The lower edges of doors, rocker
panels and frame members have a drain
hole that should not be allowed to clog
with dirt; trapped water in these areas can
cause rusting.
WARNING!
After washing the vehicle, test the
brakes while driving slowly to see
if they have been affected by water.
6-36
Aluminum wheel
maintenance
The Aluminum wheels(if fitted) are coated
with a clear protective finish.
NOTE
e Do not use any abrasive:cleaner, pol-
ishing compound, solvent, or wire
brushes on aluminum wheels. These
may scratch or damage the finish.
e Use only a mild soap or neutral deter-
gent, and rinse thoroughly with water.
Also, be sure to clean aluminum
wheels after driving on salted roads.
This helps prevent corrosion.
e Avoid washing the wheels with the
high-speed car wash brushes.
Interior General Precaution
Prevent caustic solutions such as perfume
and cosmetic oil from contacting the dash
board because they may cause damage
or discoloration. If they do contact the
dashboard, wipe them off immediately.