Kidde VS1 User Manual

Chapter 2: Front panel programming
46 P/N 3102351-EN • REV 005 • ISS 28DEC18
Default contact ID event codes
Contact ID codes are used to report events that take place in the fire alarm system to a central
monitoring station (CMS) via a dialer or over a network. The following table lists the default
Contact ID (CID) codes for panel and loop events. Some events do not have CID codes. You
can change the default code for an event or assign a code to an event that does not have one.
See “Event programming” on page 117.
Table 9: Contact ID event codes
Event
CID
AC power (disable)
500
AC power (trouble)
301
Alarm active
110
Alarm ON
115
Annunciator trouble
334
Aux. power 1 (disable)
500
Aux. power 1 (trouble)
312
Aux.
power 2 (disable) 500
Aux. power 2 (trouble)
312
Battery charger (disable)
500
Battery charger (trouble)
309
Battery low (disable)
500
Battery low (trouble)
302
Battery missing (disable)
500
Battery missing (trouble)
311
Clear history
621
CO
detected (alarm) 162
Common alarm
110
Common disable
500
Common monitor
140
Common supervisory
200
Common trouble
373
Common trouble for network dialer
373
Common trouble for telco dialer
373
Date
625
Event
CID
Device trouble
373
Device disable
570
Device
pre alarm 118
Device alarm verify
118
Device maintenance alert
393
Device test
614
Dialer disable/remote disconnect
551
Dialer line 1 fault (disable)
500
Dialer line 1 fault (trouble)
351
Dialer line 2 fault (disable)
500
Dialer line 2 fault
(trouble) 352
Dialer deliver fail
354
Dialer normal test
602
Dialer abnormal test
608
Dialer configuration
354
Drill
601
Duct active
116
Ground fault (disable)
500
Ground fault (trouble)
310
Heat active
114
Internal fault
307
IP Gateway Trouble
354
Loop 1 device 000
008
Loop 1 initialization
000
Loop 1 fault (disable)
500
Loop 1 fault (trouble)
331

Kidde VS1 Specifications

General

Brand	Kidde
Model	VS1
Category	Fire Alarms
Language	English