To Next PageTo Next Page
Need help?Do you have a question about the Kikusui PLZ205W and is the answer not in the manual?
Procedure for connecting the power cord and preparing the unit for operation.
Overview of the five operation modes available on the PLZ-5W.
Description of different alarm types and their operational behavior.
How to configure overcurrent, overpower, and undervoltage protection.
How to start, stop, and configure measurement recording sessions.
Step-by-step instructions for connecting and enabling the remote sensing function.
Comparison and usage of ABC preset and setup memory types.
How to configure and connect units for synchronized operation.
Introduction to the sequence function and its capabilities.
Steps to create, name, and configure sequence programs.
Detailed steps for creating and configuring individual steps in a sequence.
How to run, pause, abort, and control the timing of sequence execution.
Overview of external control capabilities and necessary preparations.
How to control load settings using external voltage signals.
How to control load on/off using an external signal contact.
Introduction to connecting units in parallel to increase capacity.
How to connect multiple units of the same model for parallel operation.
Step-by-step guide for physically connecting units for parallel operation.
Parameters for configuring network and serial interface settings.
Procedures to restore the unit to its original factory default state.
How to update the PLZ-5W firmware using a USB memory device.
Detailed specifications for each operation mode.
General
