9. Air velocity measurement configuration
F600
Page 20
9.a - Temperature compensation
You can modify the temperature compensation value.
The air velocity and airflow measured with a differential probe (such as Pitot tube, Debimo blade,orifice plate...)
depends on the working temperature. Then, it is required to enter the working temperature to get more
accurate results.
!
Function available only on pressure transmitters: CP 200
1
> F 100
Step
Go into configuration mode (see page 2). The folder number displayed
corresponds to the last configuration folder used.
2
> F 600
Step
Select the folder “600” and validate with .
20
3
F 600
Step
Select the sub-folder “600” to enter a value in °C
or "601" to enter a value in °F, validate with .
The cursor > returns to available choices.
>
4
Step
With and keys, enter the temperature compensation (Celsius degree
shown alongside, sub-folder "600"). Validate with .
>
20
5
F 600
Step
The cursor > returns to sub-folders line.
• press twice to return to reading mode.
• press once to return to another folder selection.
• with and keys, you can choose another sub-folder from the folder
600.
>
20
F 600
If you make a temperature compensation in Celsius degree (sub-folder "600"), the transmitter will automatically
make the conversion into Farenheit degree (sub-folder "601") and vice versa.
Class 200 transmitter configuration via keypad
To Next Page
Loading...
