KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378
18
Assist proportion value setting
The speed of each gear can be adjusted by setting the assist proportion value.To meet the
needs of different riders.
Take the first gear as an example, "30:50" is the recommended range of the first gear's
assistance proportion, and "40" is the current value of the first gear (i.e. output 40%).Add /
subtract by UP / DOWN.Short press MODE to confirm and enter the next assist proportion
setting.After setting, press and hold MODE to confirm and return to the display personalized
parameter setting interface.Refer to TABLE 4 for details.
8.5.4 Current limiting value setting
Cur is the current limiting setting.The current limit can be set in the range of 7.0-18.0
A.Change the maximum current value of the controller through UP / down.Press and hold
MODE to confirm and return to the display personalized parameter setting interface.The
factory default value of the display is 15A.
According to the different controller, the value might not be able to be 18A.
8.5.5 PAS sensor setting
The Direction of Pedal Assistant Sensor Setting
PAS means Pedal Assistant System. “run-F” means forward direction, while “run-b” means
back direction. Press UP/DOWN to select F or b, and press MODE to confirm and turn to PAS
sensitivity setting. The default direction is forward.
To Next Page
Loading...
Need help?
General
