KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378
20
8.5.7 Throttle function setting
Throttle Enable/Disable
HL means that the throttle pushing assist .HL: n indicates that the throttle has no pushing
assist function, and HL: y indicates that the throttle has a pushing function, that means, when
the handle is turned, the display will enter the pushing assist mode.Y / N can be switched
through UP / DOWN.If n is selected, press MODE to confirm and enter into the setting
interface of handle vector, otherwise, there is no response.Press and hold MODE to confirm
and return to the display personalized parameter setting interface.The factory default value of
the display is n.
Throttle vector Enable/Disable setting
HF means the throttle vector setting. HF-y means the throttle vector enable, HF-n means that
throttle vector disable.
HF-y means that when the throttle is turned, the maximum speed can only reach the
corresponding speed corresponding to the gear shown on the display.
HF-n means that the bike can reach the max speed and it is not affected by the gear limit
shown on the display when turning the throttle
Press and hold MODE to confirm and return to the display personalized parameter setting
interface.The factory default value of the display is n.
8.5.8 System settings
Delay time setting of battery power
Dy means delay time of battery power.Through UP / DOWN, the power delay time can be
To Next Page
Loading...
Need help?
General
