KINSHOFER TR07 - Page 44

Installation and initial operation
44
TR07-TR11-TR14-TR19-TR25
30.03.2020
DF10
» Counterbalance valve
incorrectly adjusted.
» Re-adjust
counterbalance valve.
» Oil flow rate not
sufficient.
» Optimise dimensioning of the
hoses.
DF10 with
upgrade kit
» Electrical connection
faulty:
» Plug connection not
connected to the display.
» Defective cable, solenoid coil
or valve.
» Connect plug connection.
» Repair cable, solenoid coil or
valve,
replace if necessary.
» No electrical contact
on the valve.
» Check valve connector under the
covering
and connect.
» Counterbalance valve
incorrectly adjusted.
» Re-adjust
counterbalance valve.
» Oil flow rate not
sufficient.
» Optimise dimensioning of the
hoses.
» Check hydraulic connections
and couplers for
tight fit.
Functional fault
Control system
Cause
Remedial measures
» Does not
» rotate or rotates
» too slowly.
CSP
Electrical connection
faulty:
» Plug connection not
connected to the outrigger.
» Defective cable, solenoid coil
or valve.
» Connect plug connection.
» Repair cable, solenoid coil or
valve,
replace if necessary.
» No electrical contact
on the valve.
» Check valve connector under the
covering
and connect.
» Faulty configuration
of the control system.
» Configure control system.
DF4
Electrical connection
faulty:
» Plug connection not
connected to the outrigger.
» Defective cable, solenoid coil
or valve.
» Connect plug connection.
» Repair cable, solenoid coil or
valve,
replace if necessary.
» No electrical contact
on the valve.
» Check valve connector under the
covering
and connect.
» Oil flow rate not
sufficient.
» Optimise dimensioning of the
hoses.
» Check hydraulic connections
and couplers for
tight fit.
DF10
» Oil flow rate not
sufficient.
» Optimise dimensioning of the
hoses.
» Check hydraulic connections
and couplers for
tight fit.