EasyManua.ls Logo

Kioti CS2610 - Installing PTO Shaft

Kioti CS2610
170 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
6
-
9
3-POINT HITCH IMPLEMENT OPERATION
Never use any other part for
pulling except draw bar. Pull-
ing with top link, ROPS and
etc. will cause a fatal accident.
Be sure to install the auxiliary
safety chain when installing a
trailer.
Improper use of the draw-bar,
even if correctly positioned,
can cause a rear overturn.
Do not overload an attachment
or towed equipment. Use prop-
er counterweights to maintain
tractor stability. Hitch heavy
loads to the draw-bar only.
Make sure that there is nobody
or not obstacle between trac-
tor and trailer.
WARNING
T66O122A
INSTALLING PTO SHAFT
H11O682A
11
C56O140A
1. Consult your local KIOTI Dealer
for selection of the PTO Shaft.
2. Wh en s electi n g a PTO S haft,
make sure that it is not too short to
come off of the female and male
shafts at the highest position or too
long to impact its female and male
shafts at the lowest position.
3. Move the joint back and forth to
check that its lock pin is properly
seated to the groove of the PTO
shaft.
(1) PTO Shaft (1) Lock Pin
M46-EU,AU-06.indd 9 2012-03-08 오후 7:02:54

Table of Contents

Related product manuals