Kioti CS2610 User Manual

4
-
22
CS2610
(1) PTO Shift Lever
This lever is to shift the PTO speed
as follows:

Rear position (A): Connecting only
to rear PTO

Middle position (B): Connecting
rear and middle PTO

Front position (C): Connecting only
to middle PTO
PTO SHIFT LEVER
M46O434A
(1) Cutting Height Adjustment Lever
CUTTING HEIGHT ADJUSTMENT LEVER
M46O452A
Cutting height is controlled by the
height adjustment control lever. The
cutting height can be set to seven dif-
ferent heights.

Deck must be in the "full up"
position before cutting height
can be changed. Do Not at-
tempt to change cutting height
with deck in any other position
than "full up".

When gauge wheels are prop-
erly adjusted, gauge wheels
will not contact the ground!
Gauge wheels are not meant
to continuously contact the
ground, the wheels act as anti
scalp rollers on the four cor-
ners of the deck.
IMPORTANT
M46-EU,AU-04.indd 22 2012-01-19 오후 1:48:47

Kioti CS2610 Specifications

General

Engine Power	24.5 hp
Engine Type	3-cylinder diesel
Transmission	Hydrostatic
Drive	4WD
Gears	Infinite (2-range)
Front tire size	18x8.5-10
PTO Speed	540 RPM
Hydraulic System Type	Open center
3-Point Hitch Category	Category 1
Fuel Capacity	6.6 gal
Rear tire size	26x12.0-12
Turning Radius	8.2 feet