Kioti CS2610 User Manual

5
-
9
OPERATION
5
JUMP STARTING THE ENGINE
(1) Dead Battery (2) Jumper Cables
(3) Helper Battery
If the battery is discharged and the
engine cannot be started, it is possible
to start the engine by connecting the
discharged battery to a battery from
another tractor or other extra battery.
1. Start the engine and run it at a low
speed and without load for approx.
3 to 4 minutes.
2. In cold weather, increase the warm
-
ing up time to 10 minutes.
3. If it is very cold, warm up the en
-
gine for approx. 15 minutes.
4. The engine throttle can be open
for 50 % in order to shorten the
warming up time.
5. The engine is sufciently warmed
up when the temperature gauge on
the instrument panel indicates 1/4
of the normal temperature range,
regardless of the warming-up time.
6. Do not increase the work load rap
-
idly after starting work.
7. Run the engine without load for
approx. 2 to 3 minutes before stop-
ping the engine after work.
HOW TO WARM UP ENGINE

Be sure to apply parking brake
while warming up the engine.

If the warm-up procedure is
skipped, the tractor can take
off abruptly to cause a fatal ac-
cident.
WARNING
WARNING

Warming up the engine exces-
sively increases fuel consump-
tion and affects the durability
of the tractor negatively.

It can cause fire and an acci-
dent.

Never leave the tractor unat-
tended while warming up.
M46O503A
M46-EU,AU-05.indd 9 2012-01-18 오후 6:38:22

Kioti CS2610 Specifications

General

Engine Power	24.5 hp
Engine Type	3-cylinder diesel
Transmission	Hydrostatic
Drive	4WD
Gears	Infinite (2-range)
Front tire size	18x8.5-10
PTO Speed	540 RPM
Hydraulic System Type	Open center
3-Point Hitch Category	Category 1
Fuel Capacity	6.6 gal
Rear tire size	26x12.0-12
Turning Radius	8.2 feet