3. Align it to the groove and pull the
set pin to release it.
4. Fix the ROPS with the grip bolt.
M46O511A
(1) Chocks (2) Parking Brake Lever
PARKING
1. This tractor is not equipped with a
separate parking brake. However
uses the brake pedals instead.
2. Pull the parking brake lever (2) up
with the brake pedals depressed
fully to engage the pedals with the
latch. If the braking force is insuf-
ficient, depress the pedals more
rmly.
3. Before leaving the tractor after
parking it, make sure to stop the
P.T.O lower the implement onto the
ground, and stop the engine.
4. If it is necessary to leave the tractor
with the engine running, put all the
shift levers in the neutral position
and apply the parking brake rmly.
5. When parking the tractor on a
slope, stop the engine with the
parking brake applied and engage
the low speed gear. Also, put the
shuttle shift lever into the forward
driving position on an uphill and
into the reverse driving position on
a downhill.
(1) Grip Bolt (2) Set Pin
M46O507A
To Next Page
Loading...
