DRIVING ON SLOPE
1. Please drive according to the con-
ditions of the slope at safe speed
so that the engine is not under
heavy load if possible.
2. Make sure to shift to the lower
gear in order to prevent the engine
from stalling on an uphill.
3. On the downhill slope, drive at low
speed.
"Unlike a gas pedal, these HST
pedals act like a main speed
shift in a mechanical trac-
tor". Therefore, depress them
deeper to obtain higher speed
with lower torque and release
them to obtain lower speed
with higher torque.
For heavy load job, such as
front end loader operation,
use low or medium speed of
the range shift lever.
IMPORTANT
Make sure that the coupling
device of brake pedal and dif-
ferential lock pedal are surely
released.
Before entering a steep slope,
move the shift lever down to
a proper gear and never try to
move the shift lever on a slope.
A serious accident can occur.
WARNING
CAUTIONS CONCERNING PAVED
ROAD
1. Make sure that the left and right
pedals are connected.
2. Go in and out of the cultivated land
at a right angle.
3. Enter and exit the eld by driving
the tractor at a right angle to the
bank.
4. When going up, lower the imple-
ment not to let the front wheel rise.
Raise the implement as soon as
the front and rear wheels are over
the bank.
5. It is recommended to use the 4WD
and drive backward when moving
onto a bank.
T85O536A
To Next Page
Loading...
Need help?
General
