Kioti CS2610 User Manual

7
-
13
MAINTENANCE
7
CHANGING ENGINE OIL AND REPLACING FILTER (L)
(1) Drain Plug (1) Engine Oil Filter
5. Remove the oil filter behind the
cooling fan on the right side of the
engine.
6. Apply a thin lm of oil to the O-ring
of a new filter and tighten the
O-ring rmly by hand.
7. Add the engine oil to the specied
level and tighten the oil lter to the
specied torque.
1. Park the tractor on level ground
and start the engine to warm it up.
2. Stop the engine, apply the parking
brake, and remove the drain plug.
3. To drain the used oil, remove the
drain plug at the bottom of the en-
gine and drain the oil completely
into the oil pan.
All the used oil can be drained out
easily when the engine is still warm.
4. Remove engine oil ller cap to al-
low easy draining of engine oil.
M46O707A
(1) Oil Inlet Plug (2) Gauge
(A) Oil level is acceptable within this range
M46O711A M46O712A
M46-EU,AU-07.indd 13 2012-01-18 오후 6:39:41

Kioti CS2610 Specifications

General

Engine Power	24.5 hp
Engine Type	3-cylinder diesel
Transmission	Hydrostatic
Drive	4WD
Gears	Infinite (2-range)
Front tire size	18x8.5-10
PTO Speed	540 RPM
Hydraulic System Type	Open center
3-Point Hitch Category	Category 1
Fuel Capacity	6.6 gal
Rear tire size	26x12.0-12
Turning Radius	8.2 feet