7. Run the start motor for approx. 10
seconds to deliver oil to each part.
8. Run the engine for approx. 5 min-
utes and check if the oil warning
lamp comes on. If it does not come
on, stop the engine. (It is normal
that the oil warning lamp is off
while the engine running)
9. Check the engine oil level again
with the oil dipstick. If the level is
low, add more oil.
The engine oil filter should be
replaced when changing the en-
gine oil.
NOTE
The engine oil is very hot while
the engine is running or right
after the engine is stopped. Be
careful not to get burned.
Avoid oil contact while chang-
ing or adding engine oil and
wear eye protection to prevent
injury to eyes.
Prolonged and repeated con-
tact with the engine oil may
ca u se sk i n dis o rde r s a nd
skin cancer. If skin contact is
made, wash thoroughly with
soap or hand cleaner as soon
as possible.
Keep the used oil out of reach
of children.
WARNING
Oil capacity (with lter)
4 L (1.1 U.S.gal.)
To avoid personal injury:
Be sure to stop the engine be-
fore changing the oil or replac-
ing the lter.
Check the engine oil level be-
fore every operation of the
tractor. If the engine oil is insuf-
cient, the engine can be dam-
aged, and this is not covered by
warranty. Be sure to add engine
oil when its level is below the
lower mark of the oil dipstick.
Do not dispose of used oil and
oil filter into drainage and
other places not designated
by regulations. Observe appli-
cable reg-ulations when dis-
posing used oil and lters.
CAUTION
Use only KIOTI genuine en-
gine oil and filters to insure
smooth operation and durabil-
ity of the engine.
IMPORTANT
To Next Page
Loading...
Need help?
General
