5. Apply a thin lm of clean oil onto the
O-ring of a new lter.
6. Tighten the lter rmly until it con-
tacts the mounting surface. Tighten
the lter a half turn further by hand.
7. Run the engine for a few minutes
and then stop it after installing a
new lter.
8. Check the uid level and add uid
to the specied level.
9. Make sure that the transmission
uid does not leak through the seal.
To avoid personal injury:
Be sure to stop the engine
before changing the fluid or
replacing the lter.
Cool down the uid sufciently.
You can get burnt by hot uid.
CAUTION
To prevent serious damage to
the hydraulic system, use only
a KIOTI genuine lter.
Do not operate the tractor im-
mediately after changing the
transmission fluid. Run the
engine at medium speed for a
few minutes to prevent dam-
age to the transmission.
IMPORTANT
Oil capacity
13 L (3.4 U.S.gal.)
(1) Gauge (2) Oil Filler Plug
(A) Oil level is acceptable within range
M46O705A
(1) Air Bleeding Plug
When adding the fluid, un-
screw the bleeding plug on
the left of the hydraulic cylin-
der. Other-wise, the fluid can
overow.
IMPORTANT
M46O715A
To Next Page
Loading...
