4-25
7. Unhook and remove the AC wiring conduit
connector from the back of the upper left
side cover.
8. Remove the five screws from the upper
left side cover and remove the cover.
9. Remove the five screws from the upper
right side cover and remove the cover.
Upper Left Side
Cover (5 Screws)
AC Wiring Conduit Connector
10. Remove the ten screws from the upper rear
cover of the oven and remove the cover.
Upper Rear Cover
(10 Screws)
11. Set the control subpanel assembly in its
place on the front of the oven and hold it
in place so it does not fall.
NOTE: You will need something approximately
12-13˝
long to prop up the front of the microwave
oven in step 12.
12. Lift the front of the microwave oven and
securely prop it up so that you can access
the turntable motor.
13. Remove the two screws from the motor.
Turntable Motor
(2 Screws)
Continued on the next page.
To Next Page
Loading...
Need help?
General
