Send Time To Recipients When clicked, the router immediately sends a BACnet time
service message to the designated networks.
SNTP Time Server
A Simple Network Time Protocol Server is a network device that synchronizes the time for
devices connected to a local area network. The router receives these time messages and
rebroadcasts them as BACnet time service messages.
IP Address Enter the address of the SNTP server. The address is supplied by the IT
department.
Sync Period Select an hourly, daily, weekly, monthly, or a custom interval to send the time
synchronization message. The custom period is set in minutes.
Test Server Click to test the connection to the network SNTP server.
Daylight Saving Time
DST Status This property indicates ACTIVE when Daylight Saving Time is in effect and
INACTIVE when it is not in effect.
DST Enable Enables the router to change its time to Daylight Saving Time. The period of
Daylight Saving Time is defined by DST Start Time and DST End.
DST Auto Calculation Selecting this check box sets the type of Daylight Saving Time
calculation. When selected, the router uses a rules-based calculation for DST based on the
day of the month in DST Start Time and DST End Time. When this check box is clear, DST is
set to specific calender dates.
DST Start Time Enter the day and time that starts Daylight Saving Time.
DST End Time Enter the day and time that ends Daylight Saving Time.
Security page
The Security page sets user access to the router. Assign users to one of the five access
levels.
l The user name list must include at least one name with Administrator privileges.
l User names and passwords are case sensitive.
l Only the Custom access level can be changed.
Section 2: Configuring the BAC-5051E router KMC Controls, Inc.
24 Revision J
To Next Page
Loading...
Need help?
General