KMC Controls BAC-5051E User Manual

Routing properties
Route On Startup When selected, the router will immediately begin routing after a power
cycle or BACnet Cold start. This includes restarting the router on the Device properties page
on page 21. The router will also select the Enable Routing check box during the reset or
power up procedure.
Enable Routing When this check box is clear, routing on all ports is disabled but the router
remains an active device on the BACnet Internetwork. The MS/TP diagnostic and Routing
Status pages are still active. When routing is not enabled the background of Router Core is
gray. When routing is enabled the background is green. Routing can also be enabled or
disabled on the Routing Status page on page 37.
Use Learned Networks When selected, the router will attempt to learn the network number
being used on a port. This only works if there is at least one other router on the network that
responds to a BACnet What-Is-My-Network-Number message. If available the router
will use the learned network otherwise the router will use the configured network number.
Illustration 3–2 Routing properties
Section 3: Setting up routing KMC Controls, Inc.
36 Revision J

KMC Controls BAC-5051E Specifications

General

Brand	KMC Controls
Model	BAC-5051E
Category	Network Router
Language	English