EasyManua.ls Logo

KMW 1220 - INSTALLATION INSTRUCTIONS; TRACTOR PREPARATION

Default Icon
98 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
6. INSTALLATION INSTRUCTIONS
CAUTION: Equip your tractor with a ROPS cab or frame for your protection. See your
tractor/ROPS Operator Manual for correct seat belt usage.
Read entire instructions before beginning to install the loader. Personal injury and machine damage may be
prevented if you read and understand these instructions and special safety messages.
When you are in the tractor seat looking forward, the right and left hand sides of the tractor and loader are the
same as your right and left hand.
6.1. TRACTOR PREPARATION
6.1.1. Tractor Front Tires
Use front tires of equal size and maintain equal pressure in each tire. The pressure of the front tractor tires must
be increased to the maximum approved pressure recommended by the tire manufacturer to compensate for
additional load placed on the tires with the Front End Loader. See your tractor Operator Manual. Adjust the front
tires to the widest recommended setting on adjustable models for maximum stability. Front end weights must NOT
be used while loader is on the tractor.
Pay particular attention to “minimum tread settings” information in Installation Instructions included with your
Mounting Kit.
6.1.2. Tractor Rear Tires
Maintain equal pressure in each of the rear tires. Use the widest recommended rear wheel setting for maximum
stability.

Table of Contents