10. DISMOUNTING THE LOADER
CAUTION: Always park loader with material bucket attached to the loader.
CAUTION: When servicing the loader or leaving operator's seat for any reason, always:
Lower the loader to ground.
Turn on Comfort Drive, if equipped
Apply the parking brake securely
Shut off the engine
Turn on tractor switch so Comfort Drive Solenoid is energized.
Release all hydraulic pressure in all circuits by moving hydraulic
control lever or levers in all positions.
Return lever or levers to neutral position.
Turn off tractor switch and remove the key.
CAUTION: Do not stand, walk, or work under a raised loader or attachment unless it is securely
blocked or held in position. Accidental movement of valve handle/handles or leaks in the
hydraulic system could cause the loader to drop, or attachment to dump, causing severe injury.
CAUTION: Do not allow bystanders in loader work area.
IMPORTANT: Never allow weight of tractor to be placed on parking stands when mounting or dismounting
loader.
10.1.1. Position the loader on a hard level surface.
The more level the surface the easier the loader is to
mount and dismount.
10.1.2. Raise loader, dump bucket 90
o
to ground, and
then lower loader so that bucket cutting edge is
approximately 1/2" off of ground.
Bearing Box
Tower
Cutting edge of bucket
1/2" off of ground
10.1.3. Remove snap pins from handle pins located in
bearing boxes.
Bearing Box
Handle Pin
Snap Pin
To Next Page
Loading...