12. SKID STEER TOOL CARRIER SYSTEM
IMPORTANT: Read safety information in this section and on decal before operating attachment.
NOTE: Skid Steer Tool Carrier System is standard
equipment
WARNING: Always read and follow
operating instructions before operating
Skid Steer Tool Carrier System.
12.1. RECOMMENDED LOADER FACTORY APPROVED ATTACHMENTS
12.1.1. Use only Loader Factory Approved Attachments for mounting on this Skid Steer Tool Carrier System:
KMW 72”, 78” or 84” Bucket, Bale Spear and Pallet Fork.
12.2. NON-LOADER FACTORY ATTACHMENTS
12.2.1. If you are going to connect a non-Loader
Factory Attachment to this Skid Steer Tool Carrier
System, read and understand the following
instructions and safety information. Always make
sure Skid Steer Tool Carrier is locked onto all
attachments.
NOTE "A": If your attachment back is not running
at a 20 degree angle, your loader rollback and
dump angles will change per attachment angle
change.
NOTE "B": If your attachment point is lower than
this, your attachment may not touch the ground
when loader is fully lowered.
IMPORTANT: Failure to follow above instructions could cause damage to loader components from contact
with attachment which are not covered under warranty.
To Next Page
Loading...