KMW 1220 - FINAL MOUNTING STEPS; Securing Loader and Routing Hoses

41
11.1.8. Raise loader, position bucket 90
o
to ground
then lower until cutting edge is 1/2" off of ground.
11.1.9. Secure loader to mounting brackets as follows.
11.1.10. Reinstall handle pins to bearing boxes and
secure using snap pins.
Bearing Box
Handle Pin
Snap Pin
11.1.11. Position parking stands in attaching brackets
on inside of each boom arm. Secure using clevis pins
and hairpin cotters.
Clevis Pin and Hairpin Cotter
in Park Position.
Attaching Bracket.
Parking Stand
in Park Position.
11.1.12. Return parking stands to storage positions in
the boom crosstubes. Secure using hairpin cotters.
Parking Stand
in Storage Position.
Hairpin Cotter
in Storage Position.
11.1.13. Lower loader to ground then route and
secure loader hydraulic hoses.
11.1.14. If your loader is equipped with Comfort Drive reconnect electrical disconnect. Make sure it is routed so it
will not be damaged during loader operation.
IMPORTANT: To avoid hydraulic hose damage, be alert and make sure hoses do not catch on tractor
and/or loader during mounting or dismounting.