11.1.5. Check that lift cylinders are fully retracted.
Position loader to clear tractor muffler and hood. Then
drive tractor forward. Use tilt cylinders to position
height of bearing box top pin making sure all loader
components clear all tractor components.
Bearing Box Top Pin
Tower Top Receiver
Bearing Box
Tower
11.1.6. Align bearing box top pin with tower top
receiver guide post, both sides. Make sure loader
is centered right to left on both towers. Extend tilt
cylinders further until top bearing box pin seats
in both towers.
Tower
Bearing Box Bottom Pin
Bearing Box Centered
Right to Left on Tower
Bearing Box Top Pin
Tower Top Receiver
Guide Post
Tower Top Receiver
Bearing Box
11.1.7. Extend lift cylinders (A) slowly making sure
loader seats completely in tower top receivers (B) and
tower bottom receivers (C).
To Next Page
Loading...