KMW 1220 - SKID STEER TOOL CARRIER INSTALLATION; Handle Positions and Engagement

44
13. INSTALLATION & OPERATION OF
SKID STEER TOOL CARRIER SYSTEM
IMPORTANT: Read safety information in this section and on decal before operating attachment.
WARNING: Always read and follow operating instructions before operating Skid Steer Tool Carrier
System.
13.1. INSTALLATION INSTRUCTIONS
IMPORTANT: Do not extend bucket cylinders without Skid Steer Tool
Carrier installed on loader. Failure to follow these instructions could
cause loader damage and void warranty.
13.1.1. Install Skid Steer Tool Carrier to loader. Secure as shown.
Pivot Pin 1" x 4.44" secured with
Carriage Bolt 3/8" x 1", Hardened Flatwasher
and Acorn Lock Nut, 2 places each side
NOTE: Locate tilt cylinder grease zerk downward.
13.2. SKID STEER TOOL CARRIER HANDLES IN DISENGAGED POSITION
13.2.1. To position handles
into the handle disengaged
position, pull skid steer tool
carrier handle upward.
Pull Handles
Upward
13.3. SKID STEER TOOL CARRIER HANDLES IN ENGAGED POSITION
13.3.1. To position handles
into the handle engaged
position, push skid steer
tool carrier handle
downward until they latch
into position.
NOTE: Handles should
be positioned parallel to
ground if properly
latched.
Push Handles
Downward.