11. MOUNTING THE LOADER
CAUTION: Do not stand, walk, or work under a raised loader or attachment unless it is securely
blocked or held in position. Accidental movement of valve handle/handles or leaks in the
hydraulic system could cause the loader to drop, or attachment to dump, causing severe injury.
CAUTION: Do not allow bystanders in loader work area.
IMPORTANT: Never allow weight of tractor to be
placed on parking stands when mounting or
dismounting loader.
11.1.1. To aid in mounting and dismounting loader,
apply a small amount of grease, if needed, to each
tower in areas of tower bottom receiver (A), tower top
receiver (B), and handle pin bushing (C).
Tower
11.1.2. Slowly drive tractor forward to a position where
the loader hoses can be connected to the tractor.
NOTE: Always clean both Male and Female Quick
Couplers before connecting them. Failure to clean
couplers can cause coupler O-ring damage and oil
leakage.
11.1.3. Stop the engine. Connect the loader hydraulic
hoses.
11.1.4. Remove handle pins and snap pins from
bearing boxes.
IMPORTANT: When driving tractor into parked
loader, take care not to drive tractor too far
forward causing Comfort Drive Accumulator or
boom cross tube to contact any tractor
components. Failure to follow these instructions
could cause damage to loader, which is not
covered under warranty.
To Next Page
Loading...