8.2.4. To keep mounting kit hardware from loosening
during operation, periodically check that all loader
mounting kit hardware is torqued to specification noted
in Torque Chart, page 67.
(1) Check all mounting kit hardware torque. (Refer
to mounting kit instructions for exact quantity
and placement of hardware.)
1. Torque all loader mounting bolts during initial
installation of loader per Operators Manual.
2. The owner/operator is responsible for checking
and retorquing all loader mounting hardware
after he/she operates loader 3 to 5 hours.
3. Inspect bolt torque every 25 hours of loader
operation, if loose retighten.
4. Failure to follow these instructions may cause
tractor or loader damage.
8.2.5. During initial setup and as required apply a small
amount of grease to each loader bracket in area of top
receiver and guide. This will aid in parking loader.
(2) To aid in mounting and dismounting loader,
apply small amount of grease to these areas.
8.2.6. Before servicing your tractor, always do one of the following.
CAUTION: Do not stand, walk, or work under a raised loader or attachment unless it is securely
blocked or held in position. Accidental movement of a control lever/levers or leaks in the
hydraulic system could cause the loader to drop, or attachment to dump, causing severe injury.
(2) Position loader bucket against dump stops,
then lower to ground and relieve all hydraulic
pressure.
To Next Page
Loading...