PACKAGE CONTENTS
UNPACKING YOUR MITER SAW
To avoid injury from unexpected starting or electrical shock, do not plug the power cord into a
source of power during unpacking and assembly. The cord must remain unplugged whenever
you are adjusting/assembling the saw.
1. Remove the miter saw from the carton.
IMPORT
ANT:
Only lift the saw by the built-in carry handles located at the top and rear of the
saw.
2. Place the saw on a secure, stationary work surface.
3. Separate all parts from the packing material. Check each one with the illustration below to
make certain all items are accounted for before discarding any packing material.
If any part is missing or damaged, do not attempt to assemble the miter saw or plug in the
power cord until the missing or damaged part is correctly replaced. To avoid electric shock,
use only identical replacement parts when servicing double-insulated tools.
PARTS DESCRIPTION QUANTITY
A Miter saw 1
B Hold-down clamp 1
C Dust bag 1
D Blade wrench 1
E Miter handle 1
F 3 mm hex wrench 1
A
B
D E FC
WARNING
!
WARNING
!
To Next Page
Loading...
Need help?
General
