Kodak EasyShare DX4530

59
8 Connecting to the Computer
CAUTION:
CAUTION:CAUTION:
CAUTION:
Install Kodak EasyShare software before connecting the
camera or optional dock to the computer. Failure to do so
may cause the software to load incorrectly.
Connecting to the Computer
You can transfer pictures and videos from the camera to the computer using
either the provided USB cable or the optional Kodak EasyShare camera dock
or camera dock II. See page 61 for connecting with a camera dock.
Transferring Pictures With the USB Cable
1 Turn off the camera.
2 Plug the labeled end of the USB cable
into the labeled USB port on your computer.
See your computer User’s Guide for details.
3 Plug the other end of the USB cable into the
labeled USB port on the camera.
An optional 3-volt AC adapter is available
to save battery power (see page 95).
4 Turn on the camera.
Kodak EasyShare software prompts you
through the transfer process.
NOTE: You can also use a Kodak multi-card reader or Kodak SD multimedia
card reader-writer to transfer your pictures. Purchase accessories at a
dealer of Kodak products. See www.kodak.com/go/dx4530accessories.