Kodak EasyShare DX4530 User Manual

66
Chapter 9
Charging the Battery
The battery is not charged when you receive it.
1 Turn off the camera.
2 Make sure the battery is installed in the camera (see page 64).
3 Place the camera in the camera dock (see page 65).
m Charging begins immediately.
m The three green charging lights monitor the charging status:
m Full charging takes about 2.5 hours. After the battery is fully charged,
leave the camera in the camera dock to maintain the full charge.
m Charging stops if you turn on the camera. If the camera is left in the
camera dock with the power on, charging resumes when the camera
enters Auto Power-off (see page 95).
NOTE: The camera dock only charges the provided Kodak EasyShare Ni-MH
rechargeable battery. If you place the camera in the camera dock with
any other type of batteries, rechargeable or not, no charging takes
place. For further Troubleshooting information, see page 69.
Charging Lights on Dock II
battery partially charged
battery low
battery fully charged

Kodak EasyShare DX4530 Specifications

General

Megapixel	5 MP
Sensor type	CCD
Digital zoom	3.3 x
Optical zoom	3 x
Combined zoom	10 x
Focal length range	8 - 24 mm
Metering	automatic: multi-pattern TTL-AE
Interface	Dock Compatibility - KODAK EASYSHARE Camera Dock I, II and KODAK EASYSHARE Printer Dock 4000
Cable type	1 x A/V cable, 1 x USB cable
Minimum RAM	64 MB
Minimum processor	233 MHz
Dimensions (WxDxH)	111 x 66 x 39 mm
Camera shutter speed	1/2-1/1700 s
Minimum storage drive space	200 MB
Minimum system requirements	CD-ROM USB
Focal length (35mm film equivalent)	38 - 114 mm
Viewfinder type	Optical
Internal memory	32 MB
Compatible memory cards	mmc, sd
Display diagonal	1.8 \
I/O ports	1 x USB 1 x composite video/audio output 1 x docking station 1 x DC power input
Bundled software	KODAK EASYSHARE Software
Self-timer delay	10 s
Tripod mounting supported	Yes
Product color	Silver
Flash modes	Red-eye reduction

Weight and Dimensions

Weight	210 g