12 A-61550 July 2008
Attaching the output tray
1. Locate the output tray slots on the scanner and align the output tray
pins with the slots.
2. Snap the output tray into place.
Turning the scanner
on and finalizing
Kodak Driver
Software installation
When the USB cable and power connections have been made, and the
Kodak Software Drivers have been installed, the installation will be
complete when you turn the scanner on.
When the scanner is powered on, it goes through an initialization
process. During the initialization process, the operating system auto
detects your scanner and “Found New Hardware” messages may be
displayed.
When it is finished and ready to scan, the LED indicator will stop
flashing and stay green.
Installing application
software -
Windows
operating systems only
The Kodak Scan Validation Tool is a test application that was
automatically installed as part of the Kodak Scanner installation CD.
Refer the section entitled, “Verifying your scanner installation” in
Chapter 3 for instructions and use.
Other scanning applications are also provided on the CDs packed with
your scanner. You may also use other scanning applications not
provided with the scanner. See the User Guides provided with these
applications for instructions on how to install and use the software.
To Next Page
Loading...
