56 A-61550 July 2008
Replacing the
separator module and
separator module tires
1. Lift up the scanner cover release to unlatch the scanner cover.
2. Lift up to open the scanner cover.
3. With one hand, push the separator module release lever back and
with the other hand lift the separator module up and out of position.
4. If you are just replacing the separator module, insert the new
separator module by aligning the shaft ends and snapping it into
position.
If you are replacing the separator module tires, continue with the
next step.
5. Holding onto the separation module, rotate the release lever back
so you can access the separation roller.
To Next Page
Loading...
