A-61550 July 2008 55
6. Lift and remove one core assembly.
7. Remove each tire by sliding it off of the core.
8. Install each new tire by gently stretching it over the core.
IMPORTANT:
• Do not overstretch the tire; it may tear.
• Make sure that the tire is centered on the core and lies flat.
9. Replace the core assembly in the feed module and snap it into
place.
10.Repeat Steps 6-9 for the other core assembly.
11. Reinstall the feed module.
12.Reinstall the front roller cover.
13.Close and latch the scanner cover.
To Next Page
Loading...
