10 A-61550 July 2008
Connecting the
power cord to the
scanner
Use only the power supply that was provided with the Kodak i1400
Series Scanner. Do not substitute another power supply model or
another manufacturer’s power supply.
When the drivers have been installed, connect the power supply and
power cord to the scanner. Make sure that the power outlet is located
within 1.52 metres (5 feet) of the scanner and is easily accessible.
1. Select the appropriate AC power cord for your region from the
supply of power cords packed with your scanner.
2. Attach the power cord for your power type to the power supply.
3. Plug the output power cord from the power supply into the power
port on the scanner.
4. Plug the other end of the power cord into the wall outlet.
Disconnecting the
power cord
• Place your thumb on the arrow on the collar of the power connector
and pull it away from the scanner.
IMPORTANT: If you have not installed the Kodak Driver Software,
do that before proceeding.
To Next Page
Loading...
