20 A-61550 July 2008
Verifying your
scanner installation
The following steps help you to verify that your scanner installation was
successful. If this procedure is successful, you will be ready to use your
scanner. If it is not successful, go back and review the installation
procedures outlined in the section entitled, “Installing the scanner” in
Chapter 2.
Before you begin, be sure the scanner is on and ready to scan.
Windows operating
systems
1. Select Start>Programs>Kodak>Document Imaging>Scan
Validation Tool or click the Scan Validation Tool icon. The Scan
Validation Tool dialog box will be displayed.
2. Select TWAIN (or ISIS) for the Driver Types and Kodak Scanner
i1410/i1420/i1440 as the driver. The Scan Validation Tool dialog
box will be displayed.
3. Click the Setup icon. The main Kodak Scanner window will be
displayed.
4. Select the Default Setting Shortcut.
To Next Page
Loading...
