Kodak Scan Station 710 - 3 Installation and Getting Started; Setup Overview

A-61796 September 2014 3-1
3 Installation and Getting Started
Contents Setup overview ...............................................................................3-1
Power saver mode and activating the Scan Station........................3-1
Installing the Kodak Scan Station 700 Series - Scanner
Administration application.............................................................3-2
The main screen .............................................................................3-3
Menus .............................................................................................3-5
File menu ....................................................................................3-5
Edit menu....................................................................................3-6
Scanner menu.............................................................................3-6
Help menu...................................................................................3-9
Icons ...............................................................................................3-9
Setup overview Following is a list of things you need to do to prepare for configuring
your Scan Station 710/730EX.
• Unpack your Scan Station(s) according to the unpacking instructions
in the box that your Scan Station was packaged in.
• Setup the Scan Station and make the necessary connections. See
the Installation Guide or the section entitled, “Setting up the Scan
Station” in Chapter 1.
• Review the pre-installation checklist in Chapter 2 and gather all of the
information required to configure the Scan Station. Having this
information available in advance will help ensure an easy Scan
Station configuration.
• When the Scan Station is properly connected, press the power button
and wait a few moments for the Scan Station to start up and display
the application.
• Install the Kodak Scan Station 700 Series - Scanner Administration
application on a separate PC. See the section entitled, “Installing the
Kodak Scan Station 700 Series - Scanner Administration application”
later in this chapter for procedures.
Power saver mode
and activating the
Scan Station
By default, after 15 minutes of inactivity, the Scan Station will
automatically enter into power saver mode.
To activate the Scan Station from power saver mode press the power
button.