2-2 A-61796 September 2014
UNC names for folders — you will need to know the fully qualified
UNC name for each network folder that will be used by your Scan
Station(s). When configuring network destinations, this will be the
information entered into the Address field of the Add: Network Folder
dialog box. For example, you could create a folder called “scanfolder”
on a server called “acmeserver” that would be reserved for Scan
Station access. You would reference it by the following UNC name:
\\acmeserver\scanfolder.
NETBIOS usage — in network environments that use routers it is
common practice to block NETBIOS traffic on your router. You may
need to know the IP address of the server where you want to scan
documents. By substituting the IP address of the server instead of the
NETBIOS computer name, you can bypass the network traffic
restrictions that may cause network scanning to fail. For example, the
previously defined network address: \\acmeserver\scanfolder should be
replaced with something similar to: \\192.168.2.10\scanfolder.
Pre-installation
checklist
It is recommended that you review this checklist before configuring the
Kodak Scan Station 710/730EX. This information is needed to create
the initial configuration file to complete the installation. Locate any
information you are unsure of before creating the configuration file. See
your system or network administrator if you have questions about this
information.
Device Settings/IP Address
The following settings are found using the Scanner tab and by selecting Scanner>Modify Scanner.
Parameter Name Your Setting Chapter Reference
Automatic (DHCP) See Chapter 9, “Modifying a Scan
Station”.
IP Address Settings — Static
Static (IPv4)
IP Address
Subnet Mask
Default Gateway
Preferred DNS Server
Alternate DNS Server
Preferred WINS Server
Alternate WINS Server
Device Settings/Network Destination Credentials
The following settings are found using the Configuration tab and by selecting Edit>Device Settings.
Parameter Name Your Setting Chapter Reference
Username, Password, Domain • See Chapter 9, “Best practices” for
creating an account for your Scan
Station.
• See Chapter 4, “Configuring your
device options”.
Automatic Configuration
Schedule
To Next Page
Loading...
