A-61796 September 2014 9-5
Network
configuration options
Before you can start adding or discovering Scan Stations you must
know the IP address or the device name; preferably both.
To get the name of your Scan Station:
1. Be sure the Scan Station is on and operational.
2. Click on the Information icon on the Scan Station to display the
name and IP address if the Scan Station is connected to a network.
Adding a Scan
Station
Before adding a Scan Station to manage remotely, it is suggested that
you obtain the Scan Station name(s) and/or IP addresses and remote
access password(s) of the Scan Stations you want to add.
NOTE: The Scan Station will only have an IP address if the Scan
Station is connected to a network and has been configured.
As Scan Stations are added, the main screen will be updated.
1. Select Scanner>Add Scanner. The Add Scanner dialog box will be
displayed.
2. Enter the name of the Scan Station in the Scanner Name field.
NOTE: Acceptable values in this field are: alphanumeric characters
and a dash. No spaces or other symbols are allowed.
3. Enter the IP address. The IP address must be in IPv4 format
xxx.xxx.xxx.xxx.
To Next Page
Loading...
