KODERA CASTING C370G - Page 30

29
3)Only rear end isn’t
stripped. Or only rear
end is not even.
Isn’t the left side roller gap
too wide?
Isn’t the 《Core Diameter》 or
《Blade Move Back》 too
large?
Isn’t right side roller worn
or slipping？
Adjust left side roller gap. (Narrow it
down. See P.11-4)
Make the 《Core Diameter》 or 《Blade
Move Back》 smaller to the point
where it becomes proper.
If front end strip has no problem, enter
the values for basic screen 《Core
Diameter》 《Blade Move Back》 into
《Front End Core Diameter》 《 Front
End Blade Move Back》,
decrease the setting values for basic
screen 《Core Diameter》《Blade Move
Back》.
If the roller has grooves, replace it
with a new roller.
4)Both front and rear
end aren’t stripped.
Isn’t the 《Core Diameter》 or
《Blade Move Back》 too
large?
Make the 《Core Diameter》 or 《Blade
Move Back》 smaller to the point where
it becomes proper.
5)Entire the insulation
or stripped core wire gets
scratched.
Isn’t the left side roller gap
too narrow？
Isn’t the roller pressure too
strong？
Does the type of roller match
the material wire?
Adjust left side roller gap. (Widen it.
See P.11-4)
Adjust the roller pressure.
Depending on the material wire, the
marks form the Twill Lined roller may
be noticeable, replace it with Sand Shot
roller or Urethane roller.
6)At the base of the core
wire gets scratched.
Isn’t the numerical value for
《Core Diameter》 too small？
Increase the numerical values for
《Core Diameter》.
7)At the middle of the
core wire gets scratched.
Isn’t the numerical value for
《Blade Move Back》 too
small?
Increase the numerical values for
《Core Diameter》.