• Do not mix fuel with elements such as oil or kerosene. Failure
to comply with this prohibition will cause the non-observance
of the emissions declared by Lombardini Marine.
• Pay attention to the temperature of the oil filter when the filter
itself is replaced.
• Only check, top up and change the coolant fluid when the
engine is off and reached the ambient temperature. Coolant
fluid is polluting, it must therefore be disposed of in the correct
way.
• Do not use air and water jets at high pressures on cables,
connectors and injectors.
Important
• Only use the eyebolts A installed by Lombardini Marine to
move the engine (Fig. 3.1).
• The angle between each lifting chain and the eyebolts shall
not exceed 15° inwards.
• The correct tightening of the lifting screws is 25 Nm.
• Do not interpose spacers or washers between the eyebolts
and engine head.
To Next Page
Loading...
