K20s
Base Mode Setting
Press F key to select Base mode in Mode Select Interface and press Power key to confirm.
Start Base Option
This option is to set up base transmission parameters.
Base Mode: Manual, Repeat and AutoBase for optional to start the base station.
Diff Type: This is the correction format which base support to transmit, there are RTD,
RTCM23, RTCM30, RTCM32,CMR, SCMRX for optional.
Mask Angle: The minimum GPS satellite elevation angle permitted by a particular receiver
design. Satellites below this angle will not be used in position solution. 10-15 degree mask angle
is recommended.
To Next Page
Loading...
