11
IC-203
4. DISASSEMBLY / REASSEMBLYField Service Ver2.0 August.2005
4.1.3 Tools Required
•Standard screwdriver
• Spanner or needle-nose pliers
• PLCC pull-out tool
Caution
• Be sure to unplug the power cable, not only to turn the copier off, before attempting to make ser-
vicing.
• Do not make service for the IC Unit and the HDD with the condition that they are installed to the
copier.
Caution
• Before engaging in Disassembly/Reassembly, check to make sure that all the cables are
unplugged from the IC unit.
• DO NOT use magnetized tools in Disassembly/Reassembly to prevent the hard disk from being
affected.
• There may be occasions when boards are damaged if no appropriate grounding measures are
taken. Wear a wrist strap or others during servicing.
• Disassembly/Reassembly should be made on cushioning materials.
To Next Page