Chapter 3 Field Service
3-1
■
25 Mode
The copier has a settings feature for service, [25 mode].
This service handbook describes only settings for the print controller.
For details of the 25 mode, refer to the copier's Service Handbook.
●
Accessing the Settings
1.
Press the copier's sub power switch OFF.
2.
While pressing copy quantity setting buttons [2] and [5] on the copier operation
panel, press the copier's sub power switch ON.
3.
From the memory setting mode screen, select [1. Software SW].
The [Memory setting mode] screen appears on the operation panel.
●
Definable Settings
The framed items are the default settings.
Operation when key counter is removed (DIPSW 01-0)
Select either "Completion" or "Instantaneous stop jam" for printouts when the key counter has been
removed for a copier set to use the key counter.
Host printing cannot be performed when a key counter is installed (DIPSW 17-3)
Select either "Permit" or "Prohibit" for printouts when the key counter has been removed for a copier
set to use the key counter.
Printer isolation (DIPSW 19-0)
This setting is used to disable the print function when it is not functioning correctly, while still allow-
ing the other functions to be used.
DIPSW No.
Operation when key counter is removed
Completion Instantaneous stop jam
01-0 0 1
DIPSW No.
Host printing
Permit Prohibit
17-3 0 1
DIPSW No.
Use print function
can be used Isolated
To Next Page
Loading...
